Open source

Howto create a ramdisk
Make a RAMDisk for the Filesystems
Before you can load your filesystems onto our target board, you must first create a RAMDisk of the file systems.
Leggi articolo

Howto set framebuffer resolution
How to set linux framebuffer resolution from command line.
Come impostare la risoluzione del framebuffer di linux da linea di comando.
Leggi articolo

Booting U-boot from Atmel Serial DataFlash on the AT91RM9200-DK Board
Links to application note provides a guide for storing U-boot in Atmel's serial DataFlash connected to the SPI Chip Select 0 on the AT91RM9200-DK Board, thereby making external parallel Flash unnecessary. (C)Copyright Atmel Corp.
Leggi articolo

U-Boot workaround for set MAC on AT91RM9200
Workaround if ethernet does not work on your AT91RM9200 board but everything is fine when you use the ethernet interface in U-Boot (for example by performing a TFTP download).
(Revised)
Leggi articolo

Howto replace u-boot (1.1.4) on AT91RM9200 board
You can replace old existing u-boot on AT91RM9200DK board with the latest one (1.1.4) using the old u-boot you get already installed on the board. (* updated III *)
Leggi articolo

AT91RM9200 xmodem upload tool
If you need loading loader.bin and u-boot into a AT91 RM9200 based board with minicom use the following instructions.
The upload procedure works perfectly if you upload into the target using Xmodem protocol and HyperTerminal.
If you try to use minicom with linux you always get back 55 NAK errors and the upload fails.
Leggi articolo

Where is ksymoops
ksymoops has been removed from the kernel, this article explain where you can find it now.
Leggi articolo

AT91RM9200 UDC Tester
This is a test program for Atmel AT91RM9200 Microcontroller UDC Gadget USB device
Leggi articolo

Patch for remove framebuffer Tux penguin, clearscreen and cursor
Useful for systems with an onboard LCD controller.
If the system has to show a splashscreen immediately after starting,
You would like to put the image into some RAM from the bootloader,
initialize the LCD controller and let Linux boot behind the scenes.
Leggi articolo

Howto install and configure a tftp server
Networking equipment manufacturers allow you to backup live configurations from routers and switches to workstations via the TFTP protocol. A remotely stored configuration file is always good to have. The reverse is also true, configurations can be loaded from the server to the network device. A common use of this reverse TFTP is the application of access control lists (ACLs) and even passwords from a centralized file.
Leggi articolo

USB keyboard driver for arm-linux
Koan has developed an USB keyboard driver for ARM linux-2.4.18-rmk7
Leggi articolo

Howto set IT keyboard
Leggi articolo